Thank you Tim
I am waiting for my number to port, so I can't test the inbound stuff, however, I did have an issue with *67. I called *67 (10 digit cell phone). My cell still shows the caller ID information for my home number.
I would expect an "unknown".
Is this working for everyone else?
Thanks,
Dan
I can report the same issue here with *67. I am dialing *67 immediately followed by the ten digit number of my cell phone. The caller id info is definitely going through. I also tried *30 as well just for grins with the same results. This is with the 502 behind my router.
My intention was to have the ATA in front of the router, but even after spending quite a while on the phone with support, we just couldn't get the 502 to pull an ip address from my cable modem.
Just tried *67 again.
For the moment it isn't working, although it did yesterday...
However, when dialing from one cloned line to the other, it does show as anonymous, which it was doing yesterday.
Bummer on the code interception. Is this the "Special Feature" setting on the HT502? I looked at the options that dropdown and see that you can choose 'standard' 'CBCOM' 'RNK' or 'Huawei'. But there's no option for 'disabled' or 'none'... Do you think Grandstream would be willing to allow their vertical service code interceptions to be completely disabled?
Bookmarks