PAP2T vs RT31P2

[voip123]

I have remote management working. I have set static DHCP in the WRT to give the RT WAN a 172.20.0.103 address.

I have the Local IP on the RT set at 172.20.0.118.

When I'm hard wired to the RT, I have to manually give the laptop a 172.20.0.104 address. I use a netmask of 255.255.255.0, and gateway and DNS of 172.20.0.104.

I can't ping 172.20.0.1 from that laptop. This is probably why I'm not connecting to the VOIPo servers.

I tried enabling DHCP on the RT, but the laptop never gets an address (I started the IPs at 200 (outside what the DHCP the WRT provides).

What am I missing?

Thanks,

/c

1) you can only assign EITHER DHCP OR STATIC. You can not do both at the same time.

2) DNS is wrong. If you are using AT&T Yahoo DSL, you should use:
DNS1: 68.94.156.1
DNs2: 1561.164.8.201

[ctaranto]

1) you can only assign EITHER DHCP OR STATIC. You can not do both at the same time.

2) DNS is wrong. If you are using AT&T Yahoo DSL, you should use:
DNS1: 68.94.156.1
DNs2: 1561.164.8.201

I know it's DHCP or Static. In the WRT, I can assign "Static DHCP", meaning it gives the same IP address every time based on a MAC address.

I'm using Comcast. I got the DNS values from the WRT and put them into the RT.

/c